K-181HDU OEM HD 1.25" BEARING & HD FRONT OR REAR AXLE UPGRADE (1993 - 2001 CONQUEST / BIGFOOT)
Improve the durability and longevity of your bearings and axle by upgrading to this HD axle and Bearing Kit. This HD 1.25" bearing and HD axle and bearing upgrade kit includes a new 810-52 bearing extension to allow the new 101-95B HD bearing and 608-88 to fit properly where the old version will not allow the flange to mount properly. Kit includes a new standard inner bearing and all required hardware to mount the housing and HD axle and HD bearing onto the below model years.Fits Argo Atv Models:
Bigfoot 6x6 (1997 -2001) Serial # prior to 13028
Conquest 6x6 (1994 - 2001) Serial # prior to 19200
Conquest 8x8 (1994 - 2001) Serial # prior to 19200
Response 8x8 (1994 - 2001 Only if equipped with front or rear bearing extensions) Serial # prior to 19200
Vanguard II 6x6 (1997 - 2001 Only if equipped with front or rear bearing extensions) Serial # prior to 13174
Vanguard 6x6 (1997 - 2001 Only if equipped with front or rear bearing extensions) Serial # prior to 13174
* Check you vehicle serial number on the dashboard prior to ordering.
Kit Includes the Following Parts:
(1) 810-129 HD AXLE (OEM)
(1) 810-52 BEARING EXTENSION
(1) 606-24 BEARING EXTENSION GASKET
(1) 101-95B OUTER HD 1.25" BEARING 72MM
(1) 101-41 1" INNER BEARING
(1) 606-89 BEARING CARRIER
(1) 606-88 OUTER GREASEABLE FLANGE
(3) 606-90 CORK GASKETS 72MM
(4) 103-68 HHCS BOLT 2.0"
(4) 117-29 NYLOC LOCKNUT
(4) 108-06 LOCK WASHER
(1) 606-91 HD 4 HOLE FLANGE
(1) 606-92 HD 4 HOLE GREASEABLE FLANGE
(4) 112-138 HHCS BOLTS 7"
If your above model is a 2002 (Serial # 19200 on Conquest or # 13028 on Bigfoot and higher) order K-182HDU which does not need the new 810-52 bearing extension housing. If looking to upgrade your mid axles (Or any axle without a bearing extension installed) to the HD design order kit# K-180HDU.
If unsure what year your model is please call us at 1-888-898-2746 and a tech can look-up your model year.
* Read installation instructions above carefully.